Instructions
Installation
Linx recommends starting with circular adhesive cushion for behind the watch face, then the squares for the links, and finally the rectangular cushion for the clasp
1. Peel off white backing paper to reveal the adhesive
2. Gently place Linx adhesive cushion in desired spot
3. Apply pressure to adhesive cushion to secure to wristwatch
4. Try the watch on. If your watch still slides down your wrist, then apply another Linx adhesive pad
5. Repeat steps 1-4
​
Removal
​
Removing all Linx Cushions
1. Slowly peel off adhesive cushion
2. Let watch soak in warm water for 5 minutes
3. Use the mini plastic spatula to remove residue
4. Use microfiber towel to dry watch
5. If adhesive still on watch, follow steps 3-9 in "Removing single Linx Cushions"
​
​
​
​
DIY Adhesive Remover
​
Removing single Linx cushions
1. Slowly peel off Linx adhesive cushions
2. Remove as much residue with the mini plastic spatula or fingernail
3. Use the DIY adhesive remover and apply enough in the desired area
4. Let it sit for 2 minutes
5. use the mini plastic spatula and scrape off residue
6. Wash off area with light stream of water
7. Let it dry
8. Use the double-sided brush to clean area of removed adhesive cushion
9. Good as new!
​
​
​
​
Ingredients:
- Baking soda
- Vegetable or Canola Oil
- Dish Soap
​
Directions:
- Mix 1 part vegetable/canola oil with 2 parts baking soda with a few drops of dish soap. Stir until a thick smooth consistency. Add more baking soda or oil if needed.
​
Linx Watch Accessories TM is not liable for any damage to watch from any part of the kit. Research ingredients for your specific watch materials.
​
​
​
​
​